![]() When running the installer ubiquity -b and you get to the partitioning choose "Something Else" When I got into Ubiquity I thought I should try to use 'Something else' but couldn't figure it out so I ended up going the other route which blew the 2nd through 5th mounting steps afterwards - so I have to start from total scratch a 2nd time.įortunately while visiting this forum again just now, I saw this from a previous poster. The command to replicate and randomly assign GUIDs has to be done on two separate command lines for three drives.you can only do one replication of a drive per command line or the mdadm command will fail later on and claim there are not enough disks to combine into the array. On the first two mdadm command lines.I failed to change disks to 3 from 2 as I'm using three NVMe drives.not two In my quest to get this done on three NVMe drives I discovered and corrected two mistakes and am about to correct a third. Grub-install -boot-directory=/boot -bootloader-id=Ubuntu -target=x86_64-efi -efi-directory=/boot/efi -recheckĮfibootmgr -c -g -d /dev/sdb -p 1 -L "Ubuntu #2 " -l '\EFI\Ubuntu\grub圆4.efi ' Sgdisk -N 1 -t 1:8300 -c 1: "Linux filesystem " /dev/md1Ĭat /etc/nf > /mnt/etc/nf Mdadm -create /dev/md1 -level=0 -raid-disks=2 /dev/sd3 ![]() ![]()
0 Comments
Leave a Reply. |